How to Measure Your Solar Radiation Using Your Smartphone

What’s it like to measure solar radiation?

In a nutshell, you’ll need an antenna, a solar compass, and a solar measuring device.

The Solar Compass and the Geography Measurement Device can both be bought from a solar supply store.

You can also make your own by buying a few small solar measuring instruments.

This guide will show you how to use the two instruments.

You’ll need to buy an antenna The first thing you need to do is figure out how to make an antenna.

You need an inexpensive antenna, which can be bought on Amazon or from your local hardware store.

A cheap antenna is a little more difficult to make than a regular antenna.

To make an inexpensive one, just buy a few pieces of wire.

You could use a little wire, but this will give you less coverage than buying a proper antenna.

The best way to make a cheap antenna antenna is to buy a cheap drill.

Make sure that you drill a hole big enough to allow for a diameter of about three inches (8 cm).

Use a drill bit to drill about an inch into the base of the antenna.

If you want to make sure you don’t get any air bubbles, you can cut off the excess material and then drill a smaller hole in the base.

Make your antenna A little while after you get the antenna, you will need to solder some components to it.

Make two connections: one for the power supply and one for a battery.

Solder two pieces of electrical tape to the antenna: one piece is about 2.5 inches (7 cm) long, and the other is about 3.5 to 4 inches (10 to 15 cm) wide.

You should have a hole about 2 inches (5 cm) in diameter.

Now that you have your antenna soldered, you’re ready to use it.

Connect the power cord to the power source and attach the antenna to the outlet.

Make the antenna connection When the antenna is connected, it will show a green light.

Now, you need two things to connect it to your computer.

First, connect the power cable to the computer.

The power cable can be connected to any of the ports on your computer: a USB port, an Ethernet port, or an SD card slot.

The Ethernet port can be used for connecting a wireless network.

The SD card slots can be plugged into a standard USB port.

Make a measurement Now, when the antenna’s power is turned on, it should show the number of kilowatts (kW) it uses.

The green light will be dimmed.

Now you need an indicator for how much power the antenna uses.

Connect an LED light into the antenna connector.

Connect a USB cable from the power connector to the indicator.

Connect another USB cable to your monitor.

The LED should be shining green.

Now plug the antenna into your computer, and wait for the indicator to light up.

You will see that the number on the meter is changing as the power is being turned on.

This is a good indicator that you’ve connected the antenna properly.